Abstract
Vapor Etching(VE)was used to etch diamond wire sawn mc-silicon wafers.The vapor was generated from heating the acid mixture solution of HF-HNO3 in the volume ratio of 1:3(the total volume of the solution is 400mL)at 90 ℃.The results showed that etching for 15 minutes,saw marks can be removed and lots of small corrosion pits which appeared in big corrosion pits were densely covered with silicon wafer surface,the average size of the corrosion pits was about 1μm,while that by wet acid etch was over 10μm.The wafer surface roughness with VE method is actually 3times higher than that with traditional wet acid etching method.The effect of VE is obvious and the reflectivity is low to12.11%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
