Muscle activity with 0.5 T upright MRI-DESS to measure T2 in biceps and triceps.

Abstract

The purpose of this study was to determine if muscle activity of the biceps followed by isometric flexion changes T2 measured in the biceps. It is hypothesized that an increase in T2 will be observed in the biceps but not in the triceps after flexion exercise. Ten healthy volunteers were imaged with a one-channel neck coil while seated in a 0.5 T upright open magnetic resonance imaging (MRI) scanner using a three-dimensional double echo steady-state (DESS) sequence. Volunteers were imaged while relaxing their arm for 10, 20, and 30 minduring an isometric biceps flexion immediately following performance of biceps curls to exhaustion, and again after relaxing for 10 and 20 min. Voxel-wise T2 was calculated by fitting to a DESS signal equation in regions segmented at muscle centers to determine mean T2 . During isometric biceps flexion immediately following biceps curls, mean T2 increased (average 33%, p < 0.05) in the biceps but not in the triceps. By 20 min after curls, mean T2 decreased (p < 0.05), and was near preactivity values. In contrast, there was no change in triceps T2 across any activity or postactivity time points. Intra-rater repeatability was excellent (ICC: 0.90-0.97). This study demonstrated that measuring T2 in an active muscle is feasible using a DESS sequence in an upright open MRI scanner. This could enable the study of muscle function while the muscle is working and weight-bearing, rather than of the "fatigue" of the muscles after activity. In comparison to electromyography, MRI also enables the study of deep muscles and allows simultaneous assessment of activity and function.