Abstract
With the original worm grinding method to manufacture face-gear, the mathematical models of shaper, worm, and face-gear are established at the beginning. Subsequently, a problem of the original grinding method is illustrated that the working part of the face-gear tooth surface may not be covered completely. To overcome this problem, multistep grinding method for completely grinding the whole working part is proposed by studying contact lines of the tooth surface and singularities of the worm thread surface. The proposed method is verified in matlab with theoretical analysis. Finally, the simulations of the original method and the multistep method in the vericut software verify the feasibility and correctness of the proposed method. The study provides an effective and precise approach to grinding the face-gear.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.