Abstract
Automotive turbochargers operate over a wide range and require high efficiencies and pressure ratios. These conflicting requirements and a myriad of design parameters render iterative design techniques unfeasible. However, over the last decades the combination of numerical flow solvers and evolutionary algorithms has established itself as a viable option in the pursuit of reaching desired performance characteristics.This study seeks to perform a three-dimensional, multipoint and multiobjective optimisation of an automotive radial compressor by modifying blade shape as well as the meridional contour of the flow path. The method couples steady-state computational fluid dynamics (CFD) with a genetic algorithm (GA) to maximise isentropic efficiency in the region close to surge, while ensuring no significant reduction in choke margin.The results of two optimisation studies are presented and a flow-field analysis based on entropy generation rate is carried out revealing regions of flow improvement. The results are further compared against experimental data, indicating good agreement between the numerical and test data. The experiments however imply a detrimental impact on the surge margin for larger impeller speeds, which is attributed to unfavourable blade loading. Two additional optimisation runs are presented mitigating the effect of loading unbalance between main blade and splitter.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.