Multi-objective optimization of parametric combination of injected slub yarn for producing knitted and woven fabrics with least abrasive damage

Abstract

PurposeThis study aims to optimize the parametric combination of injected slub yarn to achieve least abrasive damage on fabrics produced from it.Design/methodology/approachSingle base injected slub yarn structural parameters, vis-à-vis slub length, slub thickness and slub frequency, were varied during preparation of yarn samples under this research work. A total of 17 yarn samples were produced according to the Box and Bhenken design of the experiment. Subsequently knitted and woven (using injected slub yarns in the weft only) fabric samples were prepared from these yarns. Yarn and fabric samples were abraded with standard instruments to see the impact of yarn structural parameters on abrasive damage of fabric in terms of fabric mass loss and appearance deterioration. From the test results, empirical models relating to slub parameters and fabric abrasion behavior were developed through a backward elimination regression approach. Subsequently, a set of optimal parametric combinations was derived with multi-objective evolutionary algorithms by using MATLAB software. This was followed by ranking all optimal solutions through technique for order preference by similarity to idle solution (TOPSIS) score analysis.FindingsThe injected slub yarn’s structural parameters have a strong influence on the abrasive damage of knitted and woven fabric. It is seen that the best suitable parametric combination of slub parameters for achieving the least abrasive damage is not the same for knitted and woven fabric.Practical implicationsThe spinner can explore this concept to find out the best suitable parametric combination during pattern making of injected slub yarn through MATLAB solution followed by TOPSIS score analysis based on their priority of criteria level to ensure better abrasion behavior of fabric produced.Originality/valueOptimization of parametric combination of injected slub yarns will help to ensure production of fabric with most resistance to abrasion for specific applications. The studies showed that the optimal solution for woven and knitted fabrics is different. The result indicates that in the case of knitted fabric, comparatively lesser slub thickness is found to be suitable for getting better fabric abrasion resistance, whereas in the case of woven fabric, comparatively higher slub thickness is found suitable for the same.