Abstract
We propose and demonstrate experimentally multimode Q-switched mode-locking (QML) fiber laser signal generation based on a long few-mode Er-doped fiber (FM-EDF). The erbium-doped profile of the fiber has been optimized to equalize the modal gain. The fiber supporting six modes has a total length of 5.5 m, a part of the fiber is used as a gain medium, and the unpumped part of the fiber is used as a saturable absorber. Multimode oscillation lasers in the state of the continuous wave laser operation, Q-switching, and QML state pulse laser operation were observed and measured at different pump powers by adjusting the polarization controller. A 1570-nm multimode QML pulse train was obtained, when the pump power was about 2.4 W. The width of the Q-switched envelope was 19 μs, and the repetition rate was 17.4 kHz. The stable mode-locked pulses repetition rate in Q-switched envelopes was 13.18 MHz. These temporal pulses can also be observed under the case of partly blocking the beam profile, and the part of the spectral signal gradually disappeared. The mode number in the laser was checked by a homemade mode selection photonic lantern. The results showed that the fiber laser had multimode oscillation, and the modes in generated signal were ≥5. The multiple transverse modes of the generated lasers are all in QML state at the same time. To the best of our knowledge, this is the first experimental demonstration of a multimode QML fiber laser using a long FM-EDF.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.