Abstract
Traditional electric transmission line fittings, which are always manufactured from thick metal slabs, possess the disadvantage of heavy weight. In this study, a new type of electrical-connection-fitting, clevis-clevis component made of high-strength steel is developed to reduce weight, and a new hot-stamping process for multilayered sheets is proposed to manufacture the component efficiently. First, the structure of the new clevis-clevis component is designed, and the corresponding tool is developed. Second, a flat-tool heat transfer experiment is conducted. The influence of the number of layers and contact pressure on the cooling rate of each sheet is investigated. The optimizing number of layers and contact pressure for the multilayered-sheet, hot-stamping process are obtained. The optimal number of layers is two, and the optimal contact pressure is more than 20 MPa. The final microstructure of each sheet is fully martensitic, and the strength is about 1500 MPa. Finally, U-shaped, double-layer-sheet hot stamping is implemented to produce a typical electrical-connection-fitting, clevis-clevis component. The bearing capacity of a four-layered clevis-clevis is tested through numerical and experimental methods. The new connection-fitting clevis-clevis component exhibits a high load capacity of 280 kN. Compared with that of the traditional component, the weight of the new component is reduced by 60%.
Highlights
Transmission line fittings are important components related to the safe operation of electrical transmission lines [1]
A multilayered-sheet heat transfer experiment was conducted with a flat to investigate kN and (b)tool the thermal behavior of multilayered sheets during hot stamping and the quenching stages
For triple-layered-sheet hot stamping, thermal dissipation was slower in the middle layer than is completely cooled down determines the final temperature curves of triple-layered sheets at different contact pressures are shown in property
Summary
Transmission line fittings are important components related to the safe operation of electrical transmission lines [1]. Bai has done similar experimental works with Ti-6Al04V specimens and H13 tool steel In their works, only a single sheet was used in the multilayered-sheet hot stamping as an increase of the number of sheets made the heat transfer between the sheet and the tool more complicated [11,12]. Hot stamping and a quenching process for a U-shaped sheet were analyzed through numerical and experimental methods. The optimal number of sheets and the contact pressure for the multilayered-sheet, hot-stamping process are obtained. The multilayered-sheet, hot-stamping process was carried out to produce a new structure of clevis-clevis
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
