Abstract
FAPbI3 perovskites are excellent candidates for fabrication of perovskite solar cells (PSCs) with high efficiency and stability. However, these perovskites exhibit phase instability problem at room temperature. In this work, to address this challenge we use methylammonium chloride (MACl) as an additive and employed a layer-by-layer thermal evaporation technique to fabricate high-quality perovskite films on a large scale of 25 cm2. The optimized perovskite films show high crystallinity with large grains in the µm-range and reveals phase stability due to the presence of MACl after the annealing process. Finally, we achieved PSCs with 17.7% and 15.9% for active areas of 0.1 cm2 and 0.8 cm2, respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
