Multilayer emulsions as delivery systems for controlled release of volatile compounds using pH and salt triggers

Abstract

Multilayer oil-in-water (M-O/W) emulsions were compared to primary oil-in-water (P-O/W) emulsions as carriers for volatile organic compounds (VOCs) under various environmental conditions (pH and salt). The M-O/W emulsion consisted of soy oil coated with β-lactoglobulin (βLG) and pectin layers. The release of VOCs with different physiochemical properties from aqueous solutions and emulsion systems was measured using static and dynamic headspace methods. The partition coefficients ( K) calculated by the phase ratio variation (PRV) method, showed different volatile release profiles between the emulsion types. An increase in VOC release was found for the unstable P-O/W emulsion at pH 5, whereas M-O/W emulsions were stable at the same pH and retained the hydrophobic VOCs. Hydrophobic interactions and hydrogen bonds with the secondary dense layer of pectin may be responsible for the improved retention. Increasing pH and ionic strength acts as a VOC release trigger to detach the pectin from the interface. The release rates from initial dynamic curves support the results under equilibrium conditions. The results of this study demonstrate the capability of using M-O/W emulsions for controlled release of VOCs, as well as an alternative system to create stable emulsions with similar VOC release profiles.