Abstract
Since synthetic quartz is essential to produce 3D resonators for numerous applications in precision electronics, in this work the surface topography of cylindrical quartz bars is investigated using the multifractal technique. The cylindrical bars were manufactured with ultrasonic machining using five SiC grits ranging from 6 to 50 μm. The machined surfaces were initially characterized by contact profilometry and scanning electron microscopy (SEM). The multifractality of the machined surfaces was scrutinized using a box-counting method applied to the images obtained with 500X magnification. The multifractal spectrum indicated that the fractal dimension f(α) and the width of the fractal spectrum Δα are dependent on the grit size, but this dependence is not monotonic. The lowest (negative) value for Δf(α) was found for 25 μm grits indicating that for these grits the lower frequency events (grooves with tens μm width occurring along the USM direction) control the surface topography much more than high-frequency events related to brittle microcracking. The abrasive wear due to the continuous slurry recycling in lateral tool-workpiece interfaces contributed to smooth the groove texture as well as the sharpness of microscopic indentations, which remained observed on the surfaces machined with 50 μm grits. The opposite paths observed for the arithmetical mean deviation of the measured profile (Ra) and Δf(α) parameters with the cutting rate measured for each grit size were valuable to differentiate flat-rough and unlevelled-rough topographies in quartz bars.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have