Abstract
In this article, a multiband microband antenna fed by a microband feeder is proposed, with a total area of 30x24x1.6 mm ^ 3 [1]. The planned antenna is printed on the FR4 epoxy resin substrate with a relative dielectric constant of 4.4 [2]. The multiband characteristics are produced by the differently shaped grooves used in the ground plane. The antenna covers two frequency bands, 24.0 GHz to 24.53 GHz, for K-band applications, and 26.7 GHz to 27.6 GHz, for Ka-band applications [3] [4]. The prototype of the expected antenna is planned and measured in advance. Ansys HFSS software simulation results are consistent with measurement result.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal for Research in Applied Science and Engineering Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
