Multiaxial cyclic behaviour of extruded and forged AZ80 Mg alloy

Abstract

The quasi-static and cyclic response of as-extruded and closed-die extruded-forged AZ80 Mg alloy forged at 250 °C and 20 mm/sec was investigated. Servo hydraulic, fully reversed, strain controlled uniaxial “push-pull”, pure torsion, and biaxial fatigue testing were also conducted on the closed-die forged alloy. Two uniaxial loading paths (pure axial and pure shear) and three different biaxial loading paths were investigated (proportional loading, and non-proportional loading at phase angles of 45° and 90°). After forging of the as-extruded billet, the yield stress in the axial direction increased by 46%, the failure elongation by 35% and the ultimate strength by 13%. The spatial variation in both the local texture, microstructure and superficial hardness throughout the cross section of the forging was investigated and discussed. The web region in the center of the forged billet exhibited a virtually fully recrystallized and refined microstructure with intense basal texture, whereas the rib regions on each side exhibited a partially recrystallized and coarser microstructure with less intense texture. The fatigue life of the forged material in the axial direction showed dramatic improvement relative to the as-extruded material at strain amplitudes which were less than 0.35%. However, at higher strain amplitudes, there are significantly higher cyclic stresses (and associated fatigue damage) in the forged material (relative to the as-extruded), resulting in a decrease in life under fully reversed strain controlled fatigue loading. For the pure axial strain path, the total amount of strain energy density (SED) observed in the stabilized response was a function of number of cycles only, and was insensitive to material condition (as-extruded or forged). However, for the forged material, of all the strain paths investigated, only the pure shear path demonstrated a significantly different relationship of total SED vs. life. Furthermore, the amount of total SED for a given number of cycles decreases when biaxial loading is introduced, though following the same general relationship as the pure axial strain path. The effect of a decrease in total SED for a given number of cycles occurred in all biaxial strain paths, with proportional being the least prominent, then 45° and 90° out of phase being progressively more pronounced respectively. Both the Smith Watson Topper (SWT) and Jahed-Varvani (JV) models were utilized to predict the fatigue life of the uniaxial and biaxial cyclic tests. Calibration of each models intrinsic parameters were done using both of the uniaxial loading paths individually, then these same parameters were used in combination with one another to predict the life in the biaxial cases. Both the SWT and JV models are capable of giving an acceptable prediction, however the JV model’s prediction is more reliable, especially when the cyclic response has pronounced asymmetry. The biaxial fatigue response is somewhat dominated by the axial component for two significant reasons; firstly, the shape of the hysteresis in the shear direction dramatically changes based on phase angle and axial strain amplitude, whereas the axial hysteresis loop remains somewhat invariant to the presence or modulation of the other loading axis. Secondly, the initial crack propagation mode is predominantly transverse to the axial direction in all strain paths except for pure shear (which exhibits longitudinal cracking). Tensile cracking dominating the biaxial failure mode provides qualitative justification of a modification factor to an existing energy based biaxial fatigue life prediction model, enabling it to predict the life of extruded and forged AZ80 Mg reliably for a variety of different biaxial strain paths.