Abstract

Photoacoustic imaging (PAI) combines optical contrast with ultrasound spatial resolution and can be obtained up to a depth of a few centimeters. Hand-held PAI systems using linear array usually operate in reflection mode using a dark-field illumination scheme, where the optical fiber output is attached to both sides of the elevation plane (short-axis) of the transducer. More recently, bright-field strategies where the optical illumination is coaxial with acoustic detection have been proposed to overcome some limitations of the standard dark-field approach. In this paper, a novel multiangle long-axis lateral illumination is proposed. Monte Carlo simulations were conducted to evaluate light delivery for three different illumination schemes: bright-field, standard dark-field, and long-axis lateral illumination. Long-axis lateral illumination showed remarkable improvement in light delivery for targets with a width smaller than the transducer lateral dimension. A prototype was developed to experimentally demonstrate the feasibility of the proposed approach. In this device, the fiber bundle terminal ends are attached to both sides of the transducer’s long-axis and the illumination angle of each fiber bundle can be independently controlled. The final PA image is obtained by the coherent sum of subframes acquired using different angles. The prototype was experimentally evaluated by taking images from a phantom, a mouse abdomen, forearm, and index finger of a volunteer. The system provided light delivery enhancement taking advantage of the geometry of the target, achieving sufficient signal-to-noise ratio at clinically relevant depths.

Highlights

  • Photoacoustic imaging (PAI) is a technique based on the photoacoustic (PA) effect, which consists of pressure waves generation due to the absorption of light [1,2,3,4,5]

  • Monte Carlo simulations were conducted to analyze the influence of the target shape and illumination scheme on light delivery

  • The geometry was obtained by segmenting an experimental B-mode image which will be shown

Read more

Summary

Introduction

Photoacoustic imaging (PAI) is a technique based on the photoacoustic (PA) effect, which consists of pressure waves generation due to the absorption of light [1,2,3,4,5]. Laser-based PAI systems use short-duration laser pulses (i.e., ~10−9 s) ensuring thermal and stress confinement. As pulsed-light propagates within the target material, its absorption increases the local temperature, causing a thermal-elastic expansion [6] and generating a pressure wave. PAI encodes the optical absorption information into pressure waves, combining optical contrast with ultrasound spatial resolution [4]. PAI can provide physiological and anatomical information of tissues by accessing their optical, thermal, and mechanical proprieties [5,7]. Since PA signal magnitude is temperature-dependent, Sensors 2020, 20, 4052; doi:10.3390/s20144052 www.mdpi.com/journal/sensors

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call