Abstract
The machining of glass-fiber-reinforced composites is complex due to their heterogeneous structures. Research has indicated that high-speed machining, at high spindle speeds and feed rates, not only increases productivity but also reduces drilling defects, such as delamination. However, there are several challenges with high-speed machining, such as the heat generated during drilling between the drill tool and chip contact surfaces that can result in hole size errors. Therefore, it is essential to determine the optimum drilling parameters. This paper presents an innovative hybrid optimization approach called Grey Entropy Fuzzy. This approach is a combination of entropy-based weight integrated Grey Relation analysis and fuzzy logic. With the consideration of all responses simultaneously, an optimum machining combination was obtained at a spindle speed of 12,000 rpm and a feed rate of 0.02 mm/rev using a drill bit with a point angle of 118° and a drill diameter of 6 mm.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
