Multi-Parameter Experimental Investigation on the Characteristics of Acidizing Effectiveness in High-Temperature Carbonate Formation

Abstract

Carbonate formation is the key reservoir in Sichuan Basin for natural gas development. Compared with the early stage of development, the burial depth of targeted formation becomes deeper, and the formation temperature gets higher. So, the characteristics of acidizing effectiveness in high-temperature carbonate formations make this evaluation slightly difficult. Currently, it is common that a single parameter is considered to study acidizing effectiveness by simulation and experiment methods. In this paper, for a more accurate investigation of acidizing effectiveness, multiple parameters, including permeability change rate, fracture conductivity, and surface roughness, were introduced by a series of experiments. It is revealed that the permeability change rate is more than 57% when using gelled acid. As the amount of diverting agent increases in diverting acid, the viscosity of the acid grows to its peak with the reaction, making it easier to block the high permeability core temporarily and divert to acidify the low permeability core, where the permeability change rate of the low permeability core goes from 51.6% to 64.2%, which shows well acidizing effectiveness. In addition, the short-term and long-term conductivity of the samples from the three different formations are more than 200 mD∙m under high closure stress. The conductivity of Maokou Formation is the largest due to its high content of carbonate minerals and high dissolution rate. And the results of long-term conductivity are consistent with those of surface roughness, making the evaluation results more reliable for acidizing effectiveness. It is worth noting that temperature is a factor that cannot be ignored in the evaluation of acidizing effectiveness because it has a great influence on the performance of the acid system, such as viscosity and the reaction-reduced rate, leading to an acidizing effectiveness affect. So, the temperature resistance of an acid system is important as well.