Multi‐objective optimization of inductive power transfer system with reconfigurable topology for misalignment tolerance

Abstract

AbstractAt present, most of the analyses or studies about inductive power transfer (IPT) with constant current (CC) output and constant voltage (CV) output are carried out without considering misalignment conditions or different gaps. An IPT system satisfying battery charging demand and anti‐misalignment requirements simultaneously is infrequent. This paper proposes a multi‐objective particle swarm optimization method of IPT reconfigurable topology to realize CC and CV modes at varying resistance conditions and wide coupling ranges. The output characteristics of an inductor–capacitor–capacitor (LCC)–LCC compensation circuit have been explored, and it is found that the secondary‐side compensated capacitors have a greater impact on the output power, which can be used to improve power regulation ability accompanied by coupling varying. Eight optimization compensated parameters of the reconfigurable topology are obtained from the Pareto front to achieve the required CC and CV charging outputs. By switching the compensated capacitors, the selected parameters can make the current and voltage fluctuation less than 9.3% and 7.9%, respectively, during the coupling charging range from 0.3 to 0.22. Moreover, primary zero voltage switching operation is achieved to enable high efficiency. The simulation and the experimental verification are carried out to verify the validity of the proposed method.