Abstract
The design of any system contemplates the elaboration of a prototype of the entire system or some parts, before the manufacturing phase. Nowadays, rapid prototyping (RP) is widely used by the designers. Achieving good manufacturing performances needs to handle various process parameters. Most works deal with single objective process parameters. The reality is quite different and the processes involve conflicting objectives. This paper addresses the multi-objective factors optimization of the fused deposition modelling (FDM) technology. The problem is converted into a single one using the weighted-sum method and then solved by resorting to two nature-inspired computing techniques, namely particle swarm optimization (PSO) and differential evolution (DE). The results obtained are compared.
Submitted Version (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal on Interactive Design and Manufacturing (IJIDeM)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
