Abstract
In typical multi-MHz inductive power transfer (IPT) systems, a change in coupling or load resistance can significantly deteriorate the end-to-end efficiency due to a deviation from the optimal load of the IPT link and suboptimal operation of the resonant inverter due to the loss of soft switching condition. This paper proposes solutions for an IPT system to operate efficiently when large changes in coupling take place. To achieve high power efficiency independent of coupling, we utilize inherent regulation properties of resonant converters to avoid losing soft switching for any coupling value, and present the optimal load to the IPT link at the maximum energy throughput coupling. A probability-based model is introduced to assess and optimize the IPT system by analyzing coupling as a distribution in time, which depends on the dynamic behavior of the wireless charging system. The proposed circuits are a Class D rectifier with a resistance compression network in the receiving end and a load-independent Class EF inverter in the transmitting end. Experiments were performed at 6.78 and 13.56 MHz verifying high efficiency for dynamic coupling and variable load resistance. End-to-end efficiencies of up to 88% are achieved at a coil separation larger than one coil radius for a system capable of supplying 150 W to the load, and the energy efficiency was measured at 80% when performing a uniformly distributed linear misalignment of 0–12.5 cm, corresponding to a receiver moving at a constant velocity over a transmitter without power throughput control.
Highlights
O NE of the essential advantages of utilizing wireless power transfer (WPT) systems is the possibility of mobility for the device being charged
Unlike our work presented here, typical high power inductive power transfer (IPT) systems for dynamic charging operate at frequencies lower than 100 kHz, where the IPT coils are designed to shape the magnetic flux of the IPT link with magnetically permeable
A combination of circuits that use inherent regulation properties of resonant converters was introduced and designed to achieve efficient operation independent of the coupling factor, in an IPT system working at multi-MHz frequencies
Summary
O NE of the essential advantages of utilizing wireless power transfer (WPT) systems is the possibility of mobility for the device being charged. The peak efficiency in both experiments (88% at 6.78 MHz and 83% at 13.56 MHz) is, to the authors’ knowledge, the highest dc–dc efficiency ever achieved with the corresponding coil separations at such frequencies These experiments show, for the first time, an IPT system with a power capability of 150 W operating at variable coupling lower than 12% at 6.78 MHz and lower than 5% at 13.56 MHz. The theoretical analysis and equations presented in this paper are for series-tuned-secondary IPT systems because the proposed topology of the rectifier is current-driven; the same design principle for variable coupling can be applied to the equations for parallel-tuned-secondary IPT systems described in [18]
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have