Abstract

Modern day process control uses digital controllers which are based on the principle of distributed rather than centralized control. Distributing controllers, sensors and actuators across a plant entails considerable wiring which can be reduced substantially by integrating the components of a control loop over a network. The other advantages include greater flexibility and higher reliability with lower hardware redundancy. The controllers and sensors are on a network and can take over the function of a failed component automatically, without the need of manual reconfiguration, thus eliminating the need of having a redundant component for each and every component. Though elaborate techniques have been developed for Single Input Single Output (SISO) systems, the major challenge lies in extending these ideas to control a practical process plant where de-centralized control is actually achieved through control of individual SISO control loops derived through de-coupling of the original system. Multiple loops increase network load and hence the sampling times associated with the control loops and makes synchronization difficult. This paper presents a methodology by which network based process control can be applied to practical process plants, with a simple direct synchronization mechanism.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.