Abstract

This work describes the design, fabrication, and testing of an Archimedean spiral or spiral antenna using polymer extrusion 3D printing of polycarbonate base material. The spiral antenna design was simulated using CST Microwave Studio®, and the resulting 3D printed antenna characterized in terms of return loss, directivity, and polarization. The antenna design was embedded into a 3D printed structure using a unique ultrasonic method while a ground plane was inserted through a thermal embedding process. These fabrication methods provide process flexibility, which allows multiple conductive antenna layers to be additively constructed in a single build sequence. The method described can be used to create unique electromagnetic structures such as waveguides directly in a 3D printed dielectric part. The spiral antenna was tested with three variations of microstrip feed line used to match 50Ω impedance and introduce a 180° phase shift between the two arms of the spiral. These include a Duroid balun attached to feed of the antenna after fabrication, a Duroid balun embedded into the polycarbonate during fabrication, and the same microstrip design fabricated out of copper mesh and embedded into the structure using the polycarbonate as a dielectric substrate. The results of these three approaches will be discussed. © 2016 Wiley Periodicals, Inc. Microwave Opt Technol Lett 58:1662–1666, 2016

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.