Multi-component Freon gas detection based on infrared tunable Fabry-Perot detector

Abstract

A multi-component Freon gas sensing system was developed based on the non-dispersive infrared (NDIR) spectroscopy, which had the advantages of simple structure and low cost. This system mainly consisted of a broadband infrared light source, a tunable Fabry-Perot (FP) detector and a small brass absorption cell. In order to improve the utilization rate of infrared light source, the absorption cell was optimized. H1301, R134a and R410A were simultaneously detected through the measurement of gas absorption spectrum. The spectral range of the FP detector was from 8.0 to 10.5 μm, and the entire spectrum was recorded by wavelength scanning. The area of measured absorbance was directly proportional to the concentration of the target gas, which was used to calibrate the sensing system. The temperature and frequency response characteristics of the system were tested. The experimental results showed that the higher the temperature, the lower the responsiveness. In addition, the system had the best signal-to-noise ratio (SNR) at 10 Hz. The minimum detection limits of H1301, R134a and R410A were achieved to be 2.5 ppm, 5.3 ppm and 4.8 ppm, respectively. The cross-interference among the gases was suppressed by using BP neural network.