Abstract

Mechanical properties of composite laminates can be tuned by either tailoring ply orientations or by using ply drops to change thickness profiles. The latter cause resin-rich pockets to form in thermoset composites that are autoclave cured after lay-down. This paper focuses on the morphology of ply drop regions with carbon fibre thermoplastic composites manufactured using in-situ consolidation with laser-assisted tape placement. Our work shows that when laying a 0° ply (parallel to the ply drop) over a ply drop then the ply readily conforms to the shape of the ply drop, eliminating voids. However, when a 90° ply covers a ply drop, the processing direction affects behaviour. When the ply ascends a ply drop, a void is created. On the other hand, when the ply descends a ply drop, the substrate changes its shape due to combined laser heat and roller pressure, leading to significantly smaller voids.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call