Abstract
BackgroundsMismatch between knee surface and prosthesis components is related to postoperative complications. Morphological differences between ethnicity and gender may affect prosthesis coverage. The purpose of this study is to describe morphological characters of resected knee surface (distal femur, proximal tibia) in the Chinese population, analyze the influence of gender and other demographical factors, and validate the effect of ethnic difference by calculating the coverage of Western-designed knee prostheses on Chinese knee surface.MethodsIntraoperative anthropometries were performed during total knee arthroplasty performed by one single team. After screening out severe deformities and bone defects, data were separated via prosthesis system. Multiple linear regression and partial correlation analysis of morphological parameters on age, gender, height, weight were used to find out independent factors influencing morphology. Based on the 5 mm-tolerance in the prosthesis, simulation on scatter plots was brought out to calculate the prosthesis coverage to the resected bone surface.ResultsA total of 865 cases of total knee arthroplasty were involved in this study. Though gender differences were found in all knee morphological parameters regardless of the type of prosthesis, significant association was only found between gender and mediolateral width of femoral surface after adjusting demographical factors (p < 0.001). The two included prosthesis systems, Genesis-II and Scorpio NRG covered most cases in at least one dimension. Males had lower complete coverage and higher no coverage rate on femurs. Asymmetry prostheses had higher lateral coverage on tibiae.ConclusionsBased on our analysis, the only confirmed demographical factor in knee morphology is gender on femoral mediolateral length. Wider femoral prostheses for males may improve results of gender-specific prostheses. The overall fitness between Western-designed prostheses and Chinese knee surface is appliable, but the ratio of complete coverage is low. Further modification of prostheses systems can aim at the number of sizes and geometrical shapes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.