Abstract
Nanocomposites of blends of poly(vinylidene fluoride) (PVDF) and poly(methyl methacrylate) (PMMA) with multiwalled carbon nanotubes (CNTs) were prepared by melt mixing and hot press molding followed by quenching or annealing (120°C, 24 h). PMMA-rich nanocomposites showed higher electrical conductivity than PVDF-rich samples at identical CNT loading. At a specific composition, the quenched nanocomposites showed electrical conductivity values three to four orders of magnitude higher than those observed in annealed samples. Measurement of the dielectric constants also supported the electrical conductivity results. In the annealed samples, agglomerated CNTs located mainly in the PVDF crystalline phase were observed. Addition of CNTs promoted the crystallization, and especially, the formation of β-crystals, which was confirmed by X-ray diffraction. The thermal behavior of nanocomposites from differential scanning calorimetry (DSC) analysis was explained in terms of the three-phase model involving the presence of the rigid amorphous fraction, the mobile amorphous fraction, and the crystalline phase. POLYM. COMPOS., 36:1195–1204, 2015. © 2014 Society of Plastics Engineers
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.