Abstract
The morphological characteristics of female flowers and their parts in six walnut genotypes were described. The number of female flowers per inflorescence ranged from 1.9 to 2.7. The length and width of female flowers were 8.0–10.1 mm, and 3.4–3.8 mm, respectively. The average length and width of the ovule for all genotypes was 0.55 mm. The largest width of the ovule was 0.59 mm in the cultivar ‘Sheynovo’, and the smallest 0.51 mm in the cultivar ‘Geisenheim 139’. A significant positive correlation was found between the length and width of female flowers (r = 0.34⁎) and between the length and width of ovules (r = 0.57⁎⁎). Also, a significant negative correlations were found between the length of female flowers and the number of female flowers in the inflorescence (−0.58⁎⁎), and between the beginning of flowering and the duration of flowering (r = −0.66⁎⁎). The average width of the megaspore for all genotypes was 13.7 μm and of the mature embryo sac 70.2 μm. The average length of the mature embryo sac was 78.1 μm. The female flower morphogenesis occurred successively and in the same order in all examined genotypes. The differences by years and between genotypes referred to the time of onset and duration of the development stages. The characteristic phases of the female flower morphogenesis are described, and their dynamics are shown graphically for each genotype. The type of dichogamy had a significant influence on the rate of flower development. A high degree of concordance was found between the phases of female flower development and the stages of megasporogenesis and megagametogenesis. The paper presents photographs of comparative developmental stages that enable the assessment of the phases of megasporogenesis and megagametogenesis according to external morphological changes on female flowers and ovules.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.