Abstract
Polymer blend system of polylactic acid (PLA) and core shell as the impact modifier was studied. PLA was melt-blended with different amount of core shell impact modifier (0 to 30 wt.%). The PLA/core shell impact modifier was prepared by single screw extruder and injection molding machine into the required specimens. Morphological properties of the blends were investigated. Scanning electron microscopy (SEM) micrographs revealed that the addition of core shell impact modifier showed a coarser dispersed phase of voids. Dynamic mechanical analysis (DMA) tests confirmed that PLA/core shell impact modifier blends were partially miscible.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
