Morphological quality of sweet corn (Zea mays L.) ears as response to soil moisture tension and phosphate fertilization in Campeche, Mexico

Abstract

a b s t r a c t In Mexico, corn production, part of which is sweet corn, is mainly destined for human consumption. In the present work, the morphological quality of sweet corn ears was assessed in response to four levels of soil moisture tension indicating irrigation start ( −5, −30, −55, and −80kPa) and three levels of phosphate fertilization (60, 80 and 100kgha −1) in carstic soils in the south­east of Mexico. A factorial experimental design with three replicates was used. The following variables were determined: fresh weight ( SCFWh ), dry weight ( SCDWh ), diameter ( SCDh ), and length ( SCLh ) of sweet corn ears, all without husk, as well as number of kernels ( NKxE ), number of unfilled kernels ( NUK ), number of rows ( NRxE ), and dry kernel weight per ear ( DKW). Yield of fresh ( YFSCh ) and dry ( YDSCh ) sweet corn ears, both without husk, and the harvest index ( HI ) were also determined. HI did not show significant statistical differences among irrigation or fertilization treatments. Regarding the other variables, the effect of the more humid treatments ( −5 and −30kPa) and the effect of the higher phosphorus doses (80 and 100kgha −1) were statistically equal ( P ≤0.01) with the lowest NUK and the highest values of all other variables; therefore, irrigation start at soil moisture tension of −30kPa and phosphate fertilization application of 80kgha −1 are recommended. At this level of soil moisture, the mean values over the three fertilization levels and all the replicates, obtained for SCFWh , SCDh , SCLh and NKxE were 198.5g, 4.39cm, 26.72cm and 467 grains, respectively. According to the regression models, moisture tensions from −11.8 to −24.0kPa, and phosphate fertilization doses from 87.7 to 102.2kgha −1 minimize NUK and maximize the values of the rest of the variables. The highest irrigation water use efficiency was found in the moisture tension treatment of −30kPa with an increase of 27kgha −1 ears for each millimeter of applied irrigation water.