Morphological changes of veins and perivenous tissues during endovenous laser coagulation using 2-μm laser radiation and various types of optical fibers

Abstract

ObjectiveTo determine the morphological changes in veins and perivenous tissues after endovenous laser coagulation (EVLC) using laser radiation with a wavelength of 1910 nm and different types of fibers (bare tip and radial). MethodsThe EVLC procedure was carried out on 22 surface veins of six sheep. The radiation source was a diode-pumped solid-state laser, which was based on a LiYF4:Tm crystal and had an emission wavelength of 1910 nm and a maximum output power of 10 W. Two types of optical fibers were used: (1) bare tip and (2) radial or radial with two rings. Histological and morphometric methods were used, and the statistical digital data were analyzed. ResultsThe use of a linear endovenous energy density of 20 J/cm and optical bare fibers for veins with diameters of 3-4 mm resulted in a slit-shaped or wide venous wall perforation. A thermal effect was observed on the perivenous connective tissue (PVCT), which caused damage to its structures. Wide perforations were accompanied by complete destruction of the PVCT in the projection of the formed defect. The distance between the remaining vein wall fragment, located opposite to the perforation, and injured small vessels was 257.7 ± 23.6 μm. The radius of thermal damage increased to 2073.5 ± 8.0 μm near the vessel perforation. Using optical radial fibers for veins with diameters of 3.9 ± 0.5 mm did not lead to perforations. The destructive effect of the laser on small vessels of the PVCT extended to a distance of 425.7 ± 22.0 μm. ConclusionsAnalysis of thermal vessel damage in perivenous tissue after EVLC with bare-tip fiber shows that in the projection of a wide perforation, the damaged vessels of the PVCT are located at a large distance from the coagulated vein wall. On the opposite side of the perforation, the distance from the coagulated vein wall to the damaged vessels of the PVCT is significantly reduced because of the minimal output of laser radiation energy through the poorly damaged part of the wall. Using an optical radial fiber facilitates the application of a uniform distribution of thermal energy to the vein wall and damage to all its layers; at the same time, it minimizes the thermal energy that extends beyond the vein wall and damages the surrounding tissue. Clinical RelevanceThe use of radiation with a wavelength of 1910 nm will make it possible to carry out endovenous laser coagulation of varicose veins at lower power values compared with radiation in the micron and one and a half micron regions of the spectrum. Understanding of morphological changes of veins and perivenous tissues after endovenous laser coagulation with 1910-nm laser radiation and different types of optical fibers (bare-tip, radial, radial 2ring) help predict possible complications and reduce their rate.