Morphological and corrosion studies of ammonium phosphate and caesium nitrate treated Al coating deposited by arc thermal spray process

Abstract

In the present studies, the Al coating deposited by arc thermal spraying process was treated with different concentrations of ammonium phosphate mono basic ((NH4)H2PO4) and caesium nitrate (CsNO3) to improve the morphology and corrosion characteristics of the coating. As coated (AC) sample exhibits pores and defects onto the surface but once the treatment was carried out, the coating shows reduction in porosity as observed by scanning electron microscopy (SEM). The treated coatings contain caesium aluminum oxide (CAO: Cs2Al2O3) and ammonium aluminum hydrogen phosphate hydrate (AHP: (NH4)3Al5H6(PO4)8.18H2O) as composite oxides identified by X-ray diffraction (XRD). Electrochemical impedance spectroscopy (EIS) results reveal that as the exposure periods are increased, the resistance to coating/treatment (Rc/t) and charge transfer resistance (Rct) of AC and 0.5 M NH4H2PO4 and 0.0025 M CsNO3 (CN2) are increased with exposure periods in artificial ocean water solution. The improvement in total impedance values at 0.01 Hz of AC sample is attributed to formation of corrosion products which fill the pores/defects of coating while CN2 sample owing to the treatment film i.e. AHP and CAO and transformation of AHP into stable form. As the amount of NH4H2PO4 and CsNO3 is increased up to 1 M and 0.005 M i.e. CN3, the AHP film dissolved and enhances the corrosion reaction. Thus, cracking is observed in corrosion products. The enhancement in corrosion resistance of CN2 sample is attributed to the formation of α-Al(OH)3 (bayerite) and Al3(PO4)2(OH)3(H2O)5 (Aluminium hydroxide phosphate hydrate: AHPH) in greater amount as corrosion products. These corrosion products of CN2 sample are stable, sparingly soluble and protective.