Monte Carlo modelling and validation of the elekta synergy medical linear accelerator equipped with radiosurgical cones

Abstract

Monte Carlo simulations of medical linear accelerator heads help in visualizing the energy spectrum and angular spread of photons and electrons, energy deposition, and scattering from each of the head components. Hence, the purpose of this study was to validate the Monte Carlo model of the Elekta synergy medical linear accelerator equipped with stereotactic radio surgical connical collimators. For this, the Elekta synergy medical linear accelerator was modelled using the EGSnrc Monte Carlo code. The model results were validated using the measured data. The primary electron beam parameters, beam size, and energy were tuned to match the measured data; a dose profile with a field size of 40 × 40 cm2 and percentage depth dose with a field size of 10 × 10 cm2 were matched during tuning. The validation of the modelled data with the measurement results was performed using gamma analysis, point dose, and field size comparisons. For small radiation fields, relative output factors were also compared. The gamma analysis revealed good agreement between the Monte Carlo modeling results and the measured data. A gamma pass rate of more than 95% was obtained for field sizes of 40 × 40 cm2 to 2 × 2 cm2 with gamma criteria of 1% and 1 mm for the dose difference (DD) and distance to agreement (DTA), respectively; this gamma pass rate was more than 98% for the corresponding values of 2% and 2 mm for the DD and DTA, respectively. A gamma pass rate of more than 99% was obtained for a percentage depth dose with 1 mm and 1% criteria. The field size was also in good agreement with the measurement results, and the maximum deviation observed was 1.1%. The stereotactic cone field also passed this analysis with a gamma pass rate of more than 98% for dose profiles and 99% for the percentage depth dose. The small field output factor exhibited a deviation of 4.3%, 3.4%, and 1.9% for field sizes of 5 mm, 7.5 mm, and 10 mm, respectively. Thus, the Monte Carlo model of the Elekta Linear accelerator was successfully validated. The validation of radio surgical cones passed the analysis in terms of the dose profiles and percentage depth dose. The small field relative output factors exhibited deviations of up to 4.3%, and to resolve this, detector-specific and field-specific correction factors must be derived.