Abstract
The paper reports the results of the computational part of an ongoing research and development project aimed at designing and optimization of a thermoelectric generator fired with natural gas. The idea of the project is to provide an independent and reliable source of power in the power range of 50–100 W for island-mode supply, tailored for remote objects of the natural gas distribution infrastructure which, for economic reason, are not connected to the electric grid. The device includes a burner as a heat source, flow channels for air and for exhaust gases and a set of thermoelectric modules generating electric current if subject to temperature difference. The pre-selected design configuration (type E) was subject to parametric optimization. A corresponding numerical model based on the Ansys/Fluent computational fluid dynamics code was built. The optimization procedure aims to maximize the temperature difference across the thermoelectric module in order to maximize the generated power output. Simultaneously, it is essential to maintain the hot-side temperature below the required technical limit of 320 °C. First, thirteen design parameters (most of them concerning geometry) influencing the target function were identified. A central value and a possible range for each parameter have been set. Next, the partial impact of each parameter on the target function was found, and the set of the design parameters was limited to eight. Finally, only five parameters were estimated to be non-monotonically related to the generated power. The impact of the selected five parameters on the target function was investigated using a central composite design optimization plan. The set of points obtained in the multi-dimensional response surface was then limited to points meeting the imposed limitation of maximum temperature. Eventually, three candidate points (i.e. three sets of design parameters) have been proposed for the next stage of the project involving an experimental set-up for the design of the prototype.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.