Abstract
Current sourceinverters (CSIs) require power switches with first quadrant current conduction and gate-controlled output characteristics as well as reverse blocking capability. Experimental demonstration of a SiC monolithic reverse blocking transistor (MRBT) suitable for CSI applications is described in this letter. The proposed device is based on the integration of a SiC JBS diode with a SiC power <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">mosfet</small> on the same chip. The cathode of the SiC JBS diode is connected to the drain of the SiC power <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">mosfet</small> by their common N <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">+</sup> substrate. The proposed device structure creates a novel SiC-based unipolar single-chip three-terminal transistor with reverse blocking capability. The measured characteristics of a 1.2 kV 4H-SiC MRBT, fabricated in a commercial six-inch wafer foundry, are reported in this letter. The devices show a diode-like <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</small> -state characteristic with a low knee voltage of 1.3 V and an <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</small> -state voltage drop of 2.8 V at 5 A. The measured reverse transfer capacitance and output capacitance for the MRBT at a drain bias of 2 and 1000 V are a factor of ∼3x and ∼1.6x smaller than the measured values for the internal <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">mosfet</small> device. Switching measurements show a 12% reduction in the gate-drain charge for the MRBT compared with the internal <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">mosfet</small> which is favorable for reducing switching losses.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
