Abstract

Cardio-respiratory monitoring during sleep is one of the basic means for assessment of personal health, and has been widely used in diagnosis of sleep disorders. This paper proposes a novel method for non-invasive and unconstrained measurement of respiration and heartbeat during sleep. A flexible piezoelectric film sensor made of aluminum nitride (AlN) material is used in this study. This sensor measures pressure fluctuation due to respiration and heartbeat on the contact surface when a subject is lying on it. Since the AlN film sensor has good sensitivity, the pressure fluctuation measured can be further separated into signals corresponding to respiration and heartbeat, respectively. In the proposed method, the signal separation is achieved using an algorithm based on empirical mode decomposition (EMD). Experiments have been conducted with three subjects. The experimental results show that respiration and heartbeat signals can be successfully obtained with the proposed method.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.