Abstract
The purpose of this study is to investigate effectiveness of the thrust force, the motor current of spindle, and the AE signals from workpiece for the monitoring of the prefailure phase and the detection of the tool breakage in drilling holes through a thin stainless steel plate (JIS SUS304). The thrust forces, the motor current, and the AE signals were measured in micro-drilling tests by using the micro-drills of 0.1 - 0.3mm in diameter. After some considerations of experimental data, it was revealed that the thrust force is the most suitable for both the monitoring of the prefailure phase and the detection of the tool breakage, the motor current for the monitoring of the prefailure phase of the tool breakage, and the AE signal for the detection of the tool breakage.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
