Abstract
Tool wear is one of the consequences of a machining process. Excessive tool wear can lead to poor surface finish, and result in a defective product. It can also lead to premature tool failure, and may result in process downtime and damaged components. With this in mind, it has long been desired to monitor tool wear/tool condition. Kernel principal component analysis (KPCA) is proposed as an effective and efficient method for monitoring the tool condition in a machining process. The KPCA-based method may be used to identify faults (abnormalities) in a process through the fusion of multi-sensor signals. The method employs a control chart monitoring approach that uses Hotelling’s T2-statistic and Q-statistic to identify the faults in conjunction with control limits, which are computed by kernel density estimation (KDE). KDE is a non-parametric technique to approximate a probability density function. Four performance metrics, abnormality detection rate, false detection rate, detection delay, and prediction accuracy, are employed to test the reliability of the monitoring system and are used to compare the KPCA-based method with PCA-based method. Application of the proposed monitoring system to experimental data shows that the KPCA based method can effectively monitor the tool wear.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
