Molybdenum(vi) catalysts obtained from η3-allyl dicarbonyl precursors: Synthesis, characterization and catalytic performance in cyclooctene epoxidation

Abstract

The oxidative decarbonylation of the η(3)-allyl dicarbonyl complexes [Mo(η(3)-C(3)H(5))Cl(CO)(2)(L)] (L = 2,2'-bipyridine (bipy) (1), 4,4'-di-tert-butyl-2,2'-bipyridine (di-tBu-bipy) (2)) by reaction with aqueous tert-butylhydroperoxide (TBHP) or H(2)O(2) gave the following compounds in good to excellent yields: the oxo-bridged dimers [MoO(2)Cl(L)](2)O (L = bipy (3), di-tBu-bipy (6)) using TBHP(10 equiv.)/CH(3)CN/r.t.; the molybdenum oxide/bipyridine hybrid material {[MoO(3)(bipy)][MoO(3)(H(2)O)]}(n) (4) and the octanuclear complex [Mo(8)O(24)(di-tBu-bipy)(4)] (7) using TBHP(50 equiv.)/H(2)O/70 °C; the oxodiperoxo complexes MoO(O(2))(2)(L) (L = bipy (5), di-tBu-bipy (8)) using H(2)O(2)(10 equiv.)/CH(3)CN/r.t. The structure of 7·x(solvent) (where solvent = CH(2)Cl(2) and/or diethyl ether) was determined by single crystal X-ray diffraction. Despite possessing the same windmill-type complex as that described previously for 7·10CH(2)Cl(2), the crystal structure of 7·x(solvent) is unique due to differences in the crystal packing. Compounds 1-8 were examined as catalysts or catalyst precursors for the epoxidation of cyclooctene using aqueous TBHP or H(2)O(2) as oxidant at 55 or 70 °C. Reactions were performed without co-solvent or with the addition of water, ethanol or acetonitrile. Cyclooctene oxide was always the only reaction product. Solids recovered after 24 h reaction at 70 °C were identified by FT-IR spectroscopy as the hybrid 4 from (1,3-5)/TBHP, complex 5 from (1,3-5)/H(2)O(2), and complex 8 from (2,6-8)/H(2)O(2). With TBHP as oxidant, the highest epoxide yields (for 24 h reaction at 70 °C) were obtained using excess H(2)O as solvent (28-38% for 1,3-5; 87-98% for 2,6-8), while with H(2)O(2) as oxidant, the highest epoxide yields were obtained using CH(3)CN as solvent (54-81% for 3-8).