Molten chloride salts for next generation CSP plants: Electrolytical salt purification for reducing corrosive impurity level

Abstract

In this work, electrolysis with a Mg anode is presented to purify the molten chloride salt (MgCl2/KCl/NaCl 60/20/20 mol.%) for reducing its corrosivity. Using a Mg anode, the production of toxic gases like Cl2 on an inert anode (e.g., tungsten) can be avoided. Moreover, compared to an inert anode, a lower over-potential is required to remove the corrosive impurity MgOH+ in the molten salt due to the high reactivity of Mg. In order to evaluate the effect of the salt purification, the cyclic voltammetry (CV) method developed in our previous work is used to in-situ measure the concentration of the corrosive MgOH+ impurity in the molten salt. The CV measurements indicate that the corrosive impurity is efficiently removed by electrolysis. For decreasing the cathode inactivation due to produced MgO on the surface, a pulsed potential applied on the tungsten cathode during electrolysis shows to be promising. This electrochemical salt purification method has shown to be promising by efficiently controlling the corrosivity of the molten chloride salt. The potentiodynamic polarization (PDP) measurements on a commercial high-temperature alloy (Incoloy 800 H) immersed in the molten salt indicate that the corrosion rate of the alloy is significantly reduced due to the salt purification. It could also lead to a reduction of the cost of the conventional salt purification step, structural container materials, and piping in next generation concentrated solar power (Gen3 CSP) plants.