Molecular modeling of cellulose in amorphous state. III. An innovative elastomeric crosslink system

Abstract

AbstractThe flexibility of molecular structures of rubber materials was evaluated using molecular modeling techniques to develop new crosslink agents which improve deformation recovery of cellulose without significant loss of the mechanical strength. Among the studied structures Poly(propylene oxide) (PPO) pentamer appears to be the most flexible and coiled one. Our calculation results showed that, cellulose crosslinked with PPO pentamers had similar deformation recovery to that crosslinked with DMDHEU. No conformation transitions were observed in these crosslinks when cellulose models were extended to 15% strain, which is consistent with the previous result that conformation transitions in crosslinks should be avoided upon extension to achieve a good recovery on crosslinked cellulose. In addition, PPO crosslinks did not significantly affect the breaking strain of cellulose based upon the cavity volume calculations, and they helped to remove the stress concentration among cellulose chains as suggested by the results of hydrogen bonding analysis. Thus, breaking strength of cellulose might not be significantly affected by PPO crosslinks as well. The preliminary experimental results confirmed above observations. Therefore, PPO pentamer appears to be a promising elastomeric backbone structure of crosslinking agents. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1821–1833, 2007