Abstract
Laser powder bed fusion (LPBF) has the advantages of high resolution and geometric freedom but can be susceptible to process failures and defects caused by inappropriate process parameters and powder conditions. This study aims to reveal and quantify the moisture effect on the qualities and properties of as-built parts with various process parameters. The results showed that the density was decreased by 7.86% with humid powder (60.0% relative humidity (RH)) compared to dry powder (3.4%RH). Expectedly, the observed low density led to the property degradation in the hardness, yield strength (YS), and ultimate tensile strength (UTS) of the humid powder by 11.7, 15.02, and 21.25%, respectively, compared to that of dry powder (3.4%RH). Interestingly, the elongation at break of the parts fabricated with humid powder (60.0%RH) was increased by 2.82%, while their YS and UTS were decreased significantly. It seems that the water molecules on the powder surface hindered the reaction between the N2 shielding gas and melted powder, which resulted in the reduction in the austenite (γ) phase by up to 4.05 wt.%. This could be mainly responsible for the decrease in both the YS and UTS of the humid powder by approximately 100 and 150 MPa, respectively. This study demonstrates that the moisture of the metal powder used for LPBF should be carefully controlled to ensure desirable as-built qualities and properties.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
