Abstract
Excessive moisture adsorbed in electrodes and separators of a Li‐ion battery hampers its performance and is, therefore, removed to a certain amount in a post‐drying process. An insufficient understanding of the process results thereby in high process costs. Cost reductions can only be achieved efficiently with an improved process understanding by modeling this post‐drying process. As process modeling requires knowledge of sorption equilibria of water in the components of the battery, the sorption equilibria of water in different anodes are determined by means of a magnetic suspension balance and compared with different experimental setups. The measured data of the adsorption isotherms are described mathematically and give an impression of the amount of moisture, which is going to adjust at an equilibrium starting from a dry anode. Moreover, the materials of the anode are evaluated for their moisture sorption behavior. It is shown that mass‐weighted sorption equilibria of water in the materials yield a good approximation of equivalent equilibria in the anode. In the investigated anodes, the binder and rheology additive carboxymethyl cellulose (CMC) accounts for the most water uptake.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.