Abstract
Two principal problems associated with the practical application of moire fringes are to obtain sufficient sensitivity for measuring small strains and to develop a simple and inexpensive technique for engraving lines on the surface of a model. This paper deals with simple solutions to both problems. It is shown that the maximum number of fringes that can be observed for a given model is independent of the gratings utilized and depend only on the geometry of the employed optical system. Examples of moire patterns corresponding to the equivalent of 6000 lines per inch and patterns of the derivatives of the displacements corresponding to the same number of lines illustrate the paper.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.