Abstract

Antimony sulfide (Sb2S3) has the potential as an absorber material in photovoltaics due to its suitable bandgap and favorable optoelectronic properties. However, its energy band positions are not extensively explored which are essential for effective charge separation and transfer. This study examines the energy band positions of Sb2S3 thin films as a function of annealing temperature. Sb2S3 thin films are grown by a combination of successive ionic layer adsorption and reaction (SILAR) and chemical bath deposition (CBD) method to enhance the crystallinity, tune the bandgap, and overall quality of Sb2S3 films to enhance the photovoltaic performance. Optical bandgap decreases from 2.41 to 1.67 eV from the as‐deposited films to annealed at 300 °C due to changes in interatomic distances. Energy band positions of Sb2S3 films are measured both by cost‐effective electrochemical cyclic voltammetry and Mott–Schottky analysis and validated the findings using ultraviolet photoelectron spectroscopy (UPS). The conductivity of Sb2S3 is found to be n‐type. Thin‐film solar cells are then fabricated by employing Sb2S3 as an absorber layer in an FTO/TiO2/Sb2S3/P3HT/Au structure, achieving an enhanced power conversion efficiency, increasing from 0.4 to 2.8% after annealing. These findings demonstrate the potential of Sb2S3 as a low‐cost absorber material for thin‐film photovoltaics.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.