Modular electromagnetic railgun accelerator for high velocity impact studies.

Abstract

A modular electromagnetic railgun accelerator facility named "RAFTAR" (i.e., Railgun Accelerator Facility for Technology and Research) has been commissioned and its performance has been characterized for high velocity impact testing on materials in a single-shot mode. In the first tests, RAFTAR demonstrated an acceleration of more than 1000m/s for an 8g solid aluminum-7075 armature projectile. The current fed was 220kA, having a muzzle time of about 1.75ms. It is a single pulse breech-fed rectangular bore (14 × 13mm2) railgun, and its 1.15m long barrel assembly consists of two parallel copper bars with an inter-gap of 13mm that are encased within 50mm thick high strength reinforced fiberglass sheets (Garolite G10-FR4) and bolted from both the sides. RAFTAR is powered by two capacitor bank modules that have a maximum stored energy of 160 kJ each (containing eight 178 μF/15kV capacitors), two high power ignitron switches, and a pulse shaping inductor. To obtain consistent acceleration of the armature inside the barrel, reversal of driving current is prevented, and its pulse duration is stretched by tactical integration of the crowbar switch and bitter coil inductor in the circuit. Armature projectile velocity measurement in-bore and outside in free space was performed by the time-of-flight technique using indigenously made miniature B-dot sensors and a novel shorting-foil arrangement, respectively. The time resolved measurement of the in-bore armature evidenced a velocity-skin-effect in the high acceleration phase. There is good agreement between the experimentally measured and theoretically predicted efficiency, confirming the optimal choice of operating parameters. The conclusion summarizes important experimental findings and analyzes the underlying causes that limit the performance of railguns.