Abstract
An extension to the Fabry-Perot interferometric method is demonstrated to calculate the optical loss and the reflectivity for optical waveguides simultaneously. The method uses an excitation of the waveguide with a broadband amplified spontaneous emission source (a superluminescent diode in our case) and curve fitting to account for the change of input power, thereby simplifying the measurement procedure. The use of a broadband source as opposed to tunable lasers allows for simultaneous measurements over multiple wavelengths and decreased sensitivity to reflections in the cavity. Further, waveguides of different lengths are measured to calculate the optical loss and the reflectivity simultaneously. It is shown that, if the value for reflectivity is assumed, there could be a large error in the measurement of loss especially for short waveguides. Optical loss for ridge waveguides is measured and compared by using a tunable laser as the input source. The method can be used for a generic case where it is suspected that the input power changes during the measurement.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
