Modification of the (Ca2 + Mg2)-ATPase protein of sarcoplasmic reticulum with 7-chloro-4-nitrobenzo-2-oxa-1,3-diazole

Abstract

The (Ca2+ + Mg2+)-ATPase (ATP phosphohydrolase (Ca2+-transporting), EC 3.6.1.38) protein of rabbit skeletal sarcoplasmic reticulum (SR) rapidly incorporated 2 mol of 7-chloro-4-nitrobenzo-2-oxa-1,3-diazole (NBD-Cl) per 10(5) g of protein with little change in the Ca2+-dependent ATPase activity. When 2 additional mol of the reagent were bound the Ca2+-ATPase, activity was inhibited. The same pattern was found for modified intact SR and the Ca2+ uptake ability was inhibited. MgATP, CaATP and MgADP protected the Ca2+-ATPase activity concurrent with a decrease of about 1 mol of the NBD group per 10(5) g protein, but the Ca2+ uptake ability was not protected. Calcium alone had no effect on the modification. The modified ATPase protein or SR formed non-serial oligomers or aggregates, but the ATPase protein remained the predominant species present. In the presence of MgATP, oligomer formation was reduced partially but the major changes in the Ca2+-ATPase activity were due to the modification of the ATPase monomer. Thiolysis of the NBD-ATPase protein with dithiothreitol did not restore the Ca2+-ATPase activity, although more than 1 mol of the NBD group was removed from cysteine residues. Cysteine residues were modified in the NBD-ATPase protein or SR when the enzyme activity was inhibited. Trypsin digestion of NBD-SR or its ATPase protein released the A, B, A1, and A2 fragments. The A fragment and its subfragment A2 contained most of the label. Substrate MgATP protection studies showed that the A1 and A2 fragments were involved in maintaining the Ca2+-ATPase activity. Reagent-induced conformational changes of these fragments rather than direct active site group labeling accounted for the loss of ATPase activity.