Abstract
Asymmetric polysulfone (PSF) membranes for gas separation were prepared via dry-wet phase inversion technique at different conditions such as coagulation bath temperature (CBT) and evaporation time (ET). The thickness of the dense layer that plays an important role on gas selectivity has been investigated by adjusting CBT and ET. Additionally, membranes were treated with mixed Ar/O2 DC glow discharge plasma in order to modify membrane wettability, surface roughness, and functional groups on the membrane surface. Scanning electron microscopy (SEM) was used to illustrate a cross sectional structure of PSF membranes. Hydrophilic properties of the membrane surfaces were analyzed via water contact angle (WCA) and surface energy measurements. Morphological structures of membrane surfaces, roughness and creation of functional groups were analyzed both before and after plasma treatment by atomic force microscopy and Fourier transform infrared spectroscopy, respectively. Experimental results show that CBT and ET can change porous voids size of the supporting layer and the dense layer thickness underneath of the membrane surface, while a mixed Ar/O2 gas plasma treatment can enhance hydrophilic properties of the asymmetric PSF membrane surfaces.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.