Modelo impreso en 3D para entrenamiento en ureteroscopia flexible, una opción de bajo coste para el entrenamiento quirúrgico

Abstract

IntroductionTraining in experimental models is a valid option that improves the outcomes and shortens surgical learning curves.Our objective was to develop a 3D printed plastic model for teaching, training and education in flexible ureteroscopy, analyzing costs and suitability for the practice of this surgical technique. MethodsA 3D printed model was developed based on a CT scan from a real-life patient's upper urinary tract. HorosTM software was used for segmentation and an FDM-Ultimaker for 3D printing.Renal calyces were numbered to be identified, as in the European Association of Urology Endoscopic Stone Treatment training curriculum, Task 4.The following were used: Innovex single-use flexible ureteroscope (Palex) and nitinol baskets (Coloplast). ResultsPrinting time was 19hours, with a total cost of €8.77.The three-dimensional model allowed the insertion of the flexible ureteroscope and the exploration of the renal calyces by urologists in training as well as in current practice of the specialty without difficulty.The model also allowed the use of baskets and the mobilization and removal of previously placed stones. ConclusionWe unveil a valid three-dimensional model for flexible ureteroscopy training exercises with reasonable costs, which will allow acquiring the necessary skills and confidence to initiate the procedure in a real-life scenario.