Abstract

Tool-edge geometry has significant effects on the cutting process, as it affects cutting forces, stresses, temperatures, deformation zone, and surface integrity. An Arbitrary-Lagrangian–Eulerian (A.L.E.) finite element model is presented here to simulate the effects of cutting-edge radius on residual stresses (R.S.) when orthogonal dry cutting austenitic stainless steel AISI 316L with continuous chip formation. Four radii were simulated starting with a sharp edge, with a finite radius, and up to a value equal to the uncut chip thickness. Residual stress profiles started with surface tensile stresses then turned to be compressive at about 140 μm from the surface; the same trend was found experimentally. Larger edge radius induced higher R.S. in both the tensile and compressive regions, while it had almost no effect on the thickness of tensile layer and pushed the maximum compressive stresses deeper into the workpiece. A stagnation zone was clearly observed when using non-sharp tools and its size increased with edge radius. The distance between the stagnation-zone tip and the machined surface increased with edge radius, which explained the increase in material plastic deformation, and compressive R.S. when using larger edge radius. Workpiece temperatures increased with edge radius; this is attributed to the increase in friction heat generation as the contact area between the tool edge and workpiece increases. Consequently, higher tensile R.S. were induced in the near-surface layer. The low thermal conductivity of AISI 316L restricted the effect of friction heat to the near-surface layer; therefore, the thickness of tensile layer was not affected.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.