Abstract
ABSTRACTSea surface temperature (SST) from four Nucleus for European Modelling of the Ocean (NEMO) model simulations is analyzed to study the bulk flux parameterization to compute SST over the Hudson Bay Complex (HBC) for the summer months (August and September) from 2002 to 2009. The NEMO simulation was forced with two atmospheric forcing sets with different resolutions: the Coordinated Ocean-ice Reference Experiment, version 2 (COREv2), as the lower resolution and the Canadian Meteorological Centre’s Global Deterministic Prediction System Reforecasts (CGRF) as the higher resolution. The CGRF forcing is also implemented in the third and fourth runs using different runoff data and different NEMO resolutions (1/12° versus 1/4°). Results show that all four modelled SSTs followed observed SST patterns, with regional differences in SST bias between simulations with different atmospheric forcing. The SST differences are small between simulations forced with the same atmospheric forcing but with different model resolution or runoff. This implies that the model resolution and runoff have a small effect on the simulated SST in the HBC. Moreover, to better capture the effect of near-surface temperature (Tair) on simulated SST, we conducted three analyses using the Haney flux linearization formula. Results from these assessments did not indicate any direct influence on the model-simulated SSTs by Tair. Looking at the heat flux as a signature for SST showed that both averaged spatial distribution and time series of net heat flux produced by the three CGRF forcing simulations were higher than the net heat flux generated by the CORE 2 simulation. This was generally true for all four components of the total heat flux (sensible, latent, shortwave, and longwave) individually as well. Total heat flux in summer is governed by the shortwave heat flux, with values up to 120 W m−2 in August, and the longwave heat flux is the main contributor to the total heat flux differences. These heat flux differences lead to corresponding colder model SSTs for the CGRF runs and warmer SSTs for the CORE 2 simulations.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
