Abstract
BackgroundPressurised anaerobic digestion allows the production of biogas with a high content of methane and, at the same time, avoid the energy costs for the biogas upgrading and injection into the distribution grid. The technology carries potential, but the research faces practical constraints by a.o. the capital investment needed in high-pressure reactors and sensors and associated sampling limitations. In this work, the kinetic model of an autogenerative high-pressure anaerobic digestion of acetate, as the representative compound of the aceticlastic methanogenesis route, in batch configuration, is proposed to predict the dynamic performance of pressurised digesters and support future experimental work. The modelling of autogenerative high-pressure anaerobic digestion in batch configuration, which is not extensively studied and simulated in the present literature, was developed, calibrated, and validated by using experimental results available from the literature.ResultsUnder high-pressure conditions, the assessment of the Monod maximum specific uptake rate, the half-saturation constant and the first-order decay rate was carried out, and the values of 5.9 kg COD kg COD−1 d−1, 0.05 kg COD m−3 and 0.02 d−1 were determined, respectively. By using the predicted values, excellent fittings of the final pressure, the CH4 molar fraction and the specific methanogenic yield calculation were obtained. Likewise, the variation in the gas–liquid mass transfer coefficient by several orders of magnitude showed negligible effects on the model predictive values in terms of methane molar fraction of the produced biogas, while the final pressure seemed to be slightly influenced.ConclusionsThe proposed model allowed to estimate the Monod maximum specific uptake rate for acetate, the half-saturation rate for acetate and the first-order decay rate constant, which were comparable with literature values reported for well-studied methanogens under anaerobic digestion at atmospheric pressure. The methane molar fraction and the final pressure predicted by the model showed different responses towards the variation of the gas–liquid mass transfer coefficient since the former seemed not to be affected by the variation of the gas–liquid mass transfer coefficient; in contrast, the final pressure seemed to be slightly influenced. The proposed approach may also allow to potentially identify the methanogens species able to be predominant at high pressure.
Highlights
Pressurised anaerobic digestion allows the production of biogas with a high content of methane and, at the same time, avoid the energy costs for the biogas upgrading and injection into the distribution grid
The final C H4 molar fraction seemed not to be affected by the variation of the kinetic parameters highlighting that the composition of the biogas is mainly influenced by equilibrium reactions, i.e. ion association and dissociation reactions, and by gas transfer secondary
The final pressure was affected by the variation of the kinetic parameters investigated as: the higher the uptake rate for acetate, the higher the pressure, since the increase in the acetate uptake rate increases the methane produced, increasing in the final pressure; the higher the half-saturation value for acetate, the lower the pressure, since the increase in the acetate half-saturation value decreases the biomass growth, decreasing in the substrate consumption and the methane production; the higher the first-order decay rate, the lower the pressure, since the increase in the biomass decay rate decreases the biomass growth, decreasing in the substrate consumption and the methane production
Summary
Pressurised anaerobic digestion allows the production of biogas with a high content of methane and, at the same time, avoid the energy costs for the biogas upgrading and injection into the distribution grid. Advanced biofuels and biogas should be used for the 3.5% of the energy required for the transport sector [1]. In this context, anaerobic digestion (AD) is a well-established biological process that converts biodegradable substrates into biogas in the absence of oxygen. Anaerobic digestion (AD) is a well-established biological process that converts biodegradable substrates into biogas in the absence of oxygen This renewable energy source, mainly consisting of methane and carbon dioxide, can be used— in internal combustion engines—for the production of electrical and/or thermal energy [2, 3]. By separating CO2 from biogas, the production of biogenic methane, i.e. high purity C H4 gas, can be performed [4, 5]
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
